6/27/2023 0 Comments Turntable protractor![]() Once it is set right, the cartridge protractor must not be moved anymore. Point the sightline printed on the protractor precisely towards the tonearm pivot point. Loosen the cartridge screws just enough so it can be moved, but cannot move by itself. Place the template on your turntable, set anti skating to zero. If the scale is off, scale the template by changing the printer correction factor.Ĭut out the alignment protractor and punch or cut the spindle hole as precisely as possible. After printing, measure the height of the outer rectangle to be sure it matches the dimensions printed in the lower right corner. This can be set in the printing dialogue of your browser or operating system. ![]() It is important to print the cartridge alignment template at 100 % scale. Laminating the phono cartridge alignment protractor or putting a piece of clear packing tape over the grid will work as well. The sightline turntable protractor should be printed onto glossy photo paper to protect your stylus. If the manufacturer's overhang and offset angle must be achieved, try to find a matching alignment or set the null points accordingly. The protractor will provide the correct settings for the chosen geometry. The manufacturer's specifications can be ignored. ![]() The overhang and offset angle resulting from the alignment may be different from the specifications provided by the turntable manufacturer. The possibilites and settings available here may appear overwhelming at first, but do not worry: The default settings should be fine for most record players. This makes sightline protractors easy to use. This type of protractor uses the linear offset to figure out the placement of the template on the platter. Sightline protractors for phono cartridge alignment are universal protractors that can be used with any turntable (providied the slots in the headshell are long enough for the chosen alignment geometry).
0 Comments
Leave a Reply. |